SpeedEPart Agri-Fab 45-02992 Manual Del Usuario página 6

IMPORTANT: Make sure the tray is turned so that the
locking notch is at the front as shown in figure 8.
11. Assemble the tongue to the tray using two 3/8" x 1"
hex bolts (D), two 3/8" x 1-1/4" hex bolts (C), four 1/4"
long spacers (N), and four 3/8" nylock nuts (J) as
shown in figure 8. Tighten.
12. Assemble two 3/8" x 1-1/4" hex bolts (C), four 1/4"
long spacers (N) and two 3/8" nylock nuts (J) to the
holes on the other side of the slot in the tray. Tighten.
See figure 8.
3/8" x 1-1/4"
HEX BOLT (C)
1/4" LONG
SPACER (N)
LOCKING
NOTCH
FIGURE 8
3/8" x 1"
HEX BOLT (D)
3/8" x 1-1/4"
HEX BOLT (C)
3/8" NYLOCK NUT (J)
ENGLISH
13. Place the tray between the end plates. Temporarily
insert one 5/16" x 3/4" hex bolt (E) into each back
corner and one of the front corners of the tray to
hold end plates together at three of the four corners.
14. Rotate the middle brace up against the tongue,
aligning it on the side of the tongue that is next to
the slot in the tray. Fasten the brace to the tongue
using two 3/8" x 1" hex bolts (D) and 3/8" nylock
nuts (J). Do not tighten till step 18.
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK NUT (J)
FIGURE 9
15. Fasten the end plates to the corners of the tray using
eight 5/16" x 3/4" hex bolts (E) and 5/16" nylock nuts
(K). Do not tighten till step 18.
FIGURE 10
6
5/16" x 3/4"
HEX BOLT (E)
(Temporary)
MIDDLE
BRACE
5/16" x 3/4"
HEX BOLT (E)
5/16" NYLOCK
NUT (K)