Tabla de contenido
Publicidad
16. Place the lift handle through the slot in the tray.
Fasten the lift handle to the smaller, inner hole in the
middle wheel bracket using the bolt and nut which
you pre-assembled earlier (figure 2). Fasten the lift
handle to the larger, outer hole in the wheel bracket
using a 3/8" x 1-1/4" hex bolt (C), the shoulder spacer
(U), and a 3/8" nylock nut (J). Tighten both nylock
nuts. See figure 11.
17. Push the grip (V) onto the lift handle. See figure 11.
SHOULDER
SPACER (U)
3/8" x 1-1/4"
HEX BOLT (C)
PRE-ASSEMBLED
NUT AND HEX BOLT
FIGURE 11
ENGLISH
GRIP (V)
3/8" NYLOCK NUT (J)
CAUTION: the lift handle can drop to the
rear unexpectedly. It will not lock securely
in transport position until step "c" below
is completed.
18. Perform the following steps in sequence to assure
secure locking of the lift handle. Refer to figure 12.
a. Turn the aerator upright, then place the lift handle
into the transport locking notch at the front end of
the slot in the tray.
b. Stand on the right side of the aerator and push
against the tray, which will force the lift handle over
to the right side of the notch.
c. Keep the tray and lift handle in this alignment and
tighten the eight bolts at the corners of the tray.
d. Tighten the two bolts which fasten the middle
brace to the tray.
e. After performing these steps, some effort should
be required to shift the lift handle from the
transport locking notch over into the slot to lower
the aerator. When the aerator is raised, the lift
handle should spring back over into the transport
locking notch.
PUSH AGAINST
THIS SIDE
b
c
FIGURE 12
7
c
a
d
c
c
Publicidad
Tabla de contenido
