Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
see images
-
1
3
!
Make sure that no interference caused by the seat cover when
attaching the backrest to the base.
Height Adjustment
for Head Support and Shoulder Harnesses
see images
-
4
7
Please adjust the head support and check if the shoulder harnesses
are at the correct height according to
!
When used in harness mode, the shoulder harness height
must be even with or just above the top of child's shoulders.
!
When used in booster mode, the shoulder belt guides must be just
above child's shoulders.
Press the head support adjustment lever
until it clicks into one of the 15 positions, shown as
Adjust the seat
see image
8
18
&
&
&
4
5
6
7
5
and slide the head support
6
7
.
Child Restraint Installation
see images
1. Insert ISOFIX guides to assist with installation.
2. Place the top tether behind the vehicle seat.
3. Press the ISOFIX adjustment button located under the base, both
ISOFIX connectors can extend automatically.
4. Make sure that both ISOFIX connectors are securely attached to
their ISOFIX anchor points. The colors of the indicators on both
ISOFIX connectors should be completely green.
!
Press the ISOFIX adjustment button again while pushing the seat
back until it comes in contact with the vehicle seat backrest.
Use top tether
4
1. To extend top tether for use, press the button on tether adjuster and
pull to lengthen.
2. Connect the tether hook securely to vehicle's anchorage point. (see
vehicle owner's manual).
!
Make sure that tether hook is securely attached to the anchorage
point. Tension the tether strap until the indicator shows green
completely.
3. Press the release button
the hook to remove the top tether.
4. When not in use, top tether must be properly stored.
Removing the seat
1. To remove from the vehicle press the ISOFIX adjustment button and
pull the base back from the seat.
connectors from the vehicle's ISOFIX.
2. To prevent damage during transit, press the ISOFIX adjustment
button
-1
23
23
-2
-
9
23
15
16
17
to loosen the webbing and then detach
18
19
Then press and release the
21
22
and store the connectors into the base completely.
9
10
&
11
12
13
14
20
19
Publicidad
