Suncast BMADWR1 Instrucciones De Armado página 10

Assembly - Panels
(DV
Position the right and left sides ( A,B) upside-down as
shown. Insert the side tabs of the back ( E) into the
slots of left and right sides ( A,B). Slide the back ( E)
downward until it is fully engaged.
e
m?
.
With the smooth side facing down, position the
floor ( C) as shown. Align the tabs on floor ( C) with
the slots of left and right sides ( A, B). Slide the floor
forward to lock it in place.
TIP: The left and right sides ( A, B) may need
to spread slightly to allow the floor ( C) to slide
between. A rubber mallet may be useful to help
engage the floor ( C) completely.
lip
1
)
Align the the tabs on 1 toe kick ( D) with the slots in the sides ( A, B) and slide downward to lock into place.
2) Repeat to install the remaining toe kick ( D), as shown.
Once the toe kicks have been installed, rotate the drawer
frame to an upright position.
10