Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT: If you choose to use a power drill to assemble the product, refer to caution statements for
power drill guidelines. Damage to parts due to over-torque are not covered under Suncast's limited-warranty.
This item uses self-tapping screws in some areas. There are no pre- drilled holes. Some pressure may be
needed when starting to drive the screw. Once the screw pierces the plastic it will drive easier.
Pre-Assembly - Drawers
D
o
(F) x12
j
Using the included 4mm Hex Key, install 12 nut inserts ( F) into the left side (A), right side (B)
and small drawer (S) as shown.
IJ
ti
î
1===(
o
,ce [1,0e.
Place small drawer (S) on a flat surface with the smooth side facing up. Fold the left and right sides
upwards and then fold the back of the drawer to align the tabs and slots as shown. Apply pressure until
the tabs have completely snapped through the corner slots.
TIP: A rubber mallet may be useful to assist in engaging the tabs completely.
Repeat to assemble the large drawer (U).
6
Publicidad
