Audi 8W6.071.126 Instrucciones De Montaje página 29

– Unhook the claw fastener -15- from the installation position
on the base bracket -8- by pulling upward, then swivel down.
– Insert the claw fastener -15- over the positioning bolts -X-
above the installation aid -22- and slide on the claw fastener
carefully as far as it will go -arrow-.
– Slide the claw fasteners -15- incl. support bracket forwards
as far as it will go in the direction of travel
-direction of arrow-.
– The positioning bolts -X- must be hooked into the claw fas-
tener -15-.
– Remove the installation aid.
Caution
Slide the positioning bolts -X- as far as they will go in the claw fastener -15-.
If the claw fastener -15- will not easily slide, check the position of the roof bar and correct it.
Setting the roof bar width
Installation instructions - Audi A5 (5F) Coupé 2017 ►
⇒ " Adjusting the carrier unit width" on page 15
3 Installing/removing carrier units on the vehicle
Edition 01
9