Publicidad
Idiomas disponibles
Idiomas disponibles
4 MEMORY OPERATION
i Programming a memory
channel
You can program the following data into each
memory
channel separately.
* Operating frequency (pgs. 9, 10)
© 6 digit comment (p. 13)
* Lockout information (p. 16)
@ Set the desired frequency in frequency mode:
Push [CLR] to select frequency mode; or, push [F] then
[ENT+WX] to select a weather channel."
-Set the desired frequency or weather channel* using the
tuning dial or keypad.
@® Push [F] then [MR-MW].
* °M" blinks,
@® Select the memory channel (01-50) to be programmed
using the tuning dial or keypad.
@ Push [MR] to enter the frequency and to write a com-
ment; push [ENT] to program the frequency and to skip
writing a comment.
Push
[ENT] to program a weather channel.*
A comment
cannot be programmed with a weather channel.
* Push (CLR] to cancel programming.
® Set a desired comment as described at right.
Push [ENT] to program.
* Weather channel: U.S.A. version only.
i Programming a comment
The memory channel can display a 6-character comment
as well as a frequency.
@ Set the desired frequency in frequency mode.
@® Push [F] then [MR-MW].
@ Select the memory channel to be programmed.
@ Push [MR] to enter the frequency.
© Push the appropriate digit key several times to select the
desired character as listed below.
GD | Program | Co)
*' Hyphen is selectable between the 3rd and 4th digits only.
® Push [ENT] to program.
Pushing [A] or [W] moves the cursor.
To input characters in the same
group,
use
[A] to
move the cursor.
«To clear the entered comment,
push [CLR] before
pushing [ENT].
PROGRAMMING NOTES
.
.
K. TCuR—TIW
Publicidad
