Publicidad
Anti Balancing Blade kit
NOTE:
To avoid personal injury and fan damage,This installation
anddebugging can only be performed by fan professionals
Balancing Weight
Plastic Clip
Note: prior to using this equipment check your fan to ensure it is correctly installed and all the
blade adjustment screws are fully tightened.
Warning: on using the anti swinging equipment, ensure the weights and swinging clip are
correctly hooked onto the blades. An accident may be used should the clip and weight not be
correctly secured.
1. switch the fan on at high speed, down stream.
2. Before using the swing equipment change the adjacent blade position. If this improves the fan
swing leave it as it is, and use the swing equipmentto continue with the step 3. Should this
worsen the swing, change the blades and continue with step 3.
3. With the fan stopped, fix the swing clip securely on the entrance edge halfway between the
outer edge of the blade and the blade support.
4. Switch on the fan and observe the swing. Stop the fan and change clip to the next blade.
Switch the fan on again and observe the swing, repeat operation with the other blades.
5. Change the clip to the blade where you notice the swing. This time fix the clip on the blade
entrance edge close to the blade support. Switch on the fan and observe the swing. Stop the fan
and move the clip outwards with small increases until you find the position where the fan works
best.
Remove the protection paper from one of the adhesive strips, place the weight and stick it firmly
on the blade along the centre line on the opposite side to the clip. Remove the clip and switch on
the fan , if you do not totally remove the swing, you can adjust it better repeating the steps above
and adding another weight to the blade indicate in your second test, apart from the one used in
the first. Should you have a swinging ceiling fan, the use of this swinging equipment will help to
correct the problem.
18
EN
Publicidad
