Stahlwille TORSIOTRONIC Serie Manual De Instrucciones página 75

Undertaking settings on the PC
 Set the first number using the arrow buttons.
 Confirm with OK.
 Set the other numbers in the same manner.
After inputting the correct number, the
CONFIGURATION menu is displayed.
 Use the arrow buttons to select the desired menu
item.
 Carry out the desired settings.
The settings in the configuration menu can be
carried out on the PC independently of the
TORSIOTRONIC
®
software. An administrator password may also
be assigned here to protect against
unauthorised access to the TORSIOTRONIC
configuration. Information on this can be found
in the SENSOMASTER software online help.
Undertaking settings on the
PC
If the TORSIOTRONIC
SENSOMASTER software can be used e.g. to
exchange data between the TORSIOTRONIC
the PC.
Various settings can also be changed on the PC.
The settings are then transferred to the
TORSIOTRONIC .
®
30
using the SENSOMASTER
is connected to a PC, the
®
®
For information on operation of the
SENSOMASTER software, refer to the relevant
online help.
The following settings can be carried out on the PC
using the SENSOMASTER software and then
transferred to the TORSIOTRONIC
 Selecting units
 Assign an ID
 Set a time for the TORSIOTRONIC
automatically
 Set an alert limit
 Define a calibration date
 Assign an administrator password
 Transfer the fastening data available in the
TORSIOTRONIC
 Delete the TORSIOTRONIC
memory
 Define sequence plans
 Define fastening operations
 Set a menu language
 Configure menus
Prerequisites for connection to a PC include:
 A USB interface,
®
 Microsoft Windows,
 A micro USB cable and
 The installed SENSOMASTER software.
and
:
®
to switch off
®
memory to the PC
®
's entire internal
®