Beem Air Joy Hot&Cool Manual De Instrucciones página 16

12 EN
Intended use
This appliance is used for generating warm
and cold air flows for use in the household or
similar, non-commercial establishments such
as staff kitchens in shops, cafés, offices or
other business surroundings; agricultural es-
tablishments; use by guests in hotels, motels
or other residential facilities; bed and break-
fast establishments.
Any use other than previously stated is con-
sidered as improper use.
WARNING
If not used for its intended purpose and/or
used in any other way, the appliance may
be or become a source of danger.
► Use the appliance only for its intended
purpose.
► Observe the procedures described in
this user manual.
No claims of any kind will be accepted for
damage resulting from use of the appliance
for other than its intended purpose.
The risk must be borne solely by the user.
Requirements for the place of
operation
For safe and trouble-free operation of the ap-
pliance, the installation location must satisfy
the following requirements:
Place the appliance on a firm, dry, flat
‹
and waterproof surface.
Do not install the appliance in a hot, wet
‹
or very humid environment.
Never place the appliance or parts of the
‹
appliance in the vicinity of strong heat sour-
ces and hot surfaces (e.g., heating, oven,
grill).
Do not place the appliance in a confined,
‹
in an alcove, corner or constricted between
items of furniture. Allow sufficient space
around it so that the air can circulate.
The mains socket must be easily ac-
‹
cessible and allow fast disconnection in the
event of an emergency.
The surface finishes on furniture may
‹
contain substances that can be detrimental to
the feet of the appliance. If necessary, place
a mat under the feet of the appliance.
BEEM - Elements of Lifestyle
The appliance may not be used or stored
‹
outdoors.
Electrical connection
For safe and trouble-free operation of the
appliance, the following instructions on the
electrical connection must be observed:
Before connecting the appliance, com-
‹
pare the connection data (voltage and
frequency) on the rating plate with those of
your mains power supply. This data must
correspond in order to avoid damage to the
appliance. If in doubt, ask your electrical ap-
pliance retailer.
The mains socket must be protected by at
‹
least a 16 A fuse.
Ensure that the mains cable is undam-
‹
aged and is not laid over sharp edges.
The mains cable must not be pulled
‹
tightly, bent, crushed or knotted or come into
contact with hot surfaces sharp edges or
chemicals.
Always unwind the mains lead completely
‹
before connecting the appliance to the plug
socket.
Route the mains cable to prevent risk of
‹
tripping.
The electrical safety of the appliance is
‹
only assured when it is connected to a prop-
erly installed protective earth (PE) conductor
system. Connection to a mains socket with-
out PE conductor is forbidden. If in doubt, the
electrical system must be checked by a quali-
fied electrician. The manufacturer assumes
no liability for injury or damage caused by a
missing or interrupted protective earth con-
ductor.
Symbols used
DANGER
This indicates an imminent hazardous situ-
ation, which could lead to severe physical
injury or death.
► Follow these instructions to avoid
danger.