Publicidad
Idiomas disponibles
Idiomas disponibles
BEEM - Elements of Lifestyle
Declaration of Conformity
BEEM hereby declares that this appliance
complies with the fundamental requirements
and other relevant provisions of 2004/108/EC,
2006/95/EC, 2009/125/EC und 2011/65/EU
directives.
The following table helps in localising and remedying minor faults. If you cannot resolve the
problem with the steps described, please contact customer service.
Fault
The indicator lamp does not
light up after switching on
The indicator lamp extinguish-
es after a few seconds.
The fuse in the distributor box
triggers.
The airflow is too weak.
The appliance switches itself
off.
The appliance cannot switch to
warm air or switches itself off
after a few seconds.
Troubleshooting
Possible cause
Plug not inserted into socket.
Fuse in electrical distribution
.
board switched off.
The appliance is not stable
and the safety switched has
switched it off.
Too many appliances con-
nected to the same power
circuit.
No fault detected.
There is contamination in the
air inlets or between the air
slots.
The appliance is tipped and
the safety switched has
switched it off.
The overheat protection has
switched off the appliance
because an ambient tem-
perature of approx. 30° C
was reached and/or the setup
location is constricted.
The surrounding temperature
is too high which triggers the
overheat protection.
Remedy
Insert plug.
Switch on fuse.
Place the pedestal of
the appliance on a firm
and flat surface.
Reduce the number of
appliances on the power
circuit.
Contact customer
service.
Eliminate possible con-
tamination as described
in the section Clean-
ing and maintenance
(page 16).
Place the pedestal of
the appliance on a firm
and flat surface. so that
it cannot tip.
Allow the appliance and
surroundings to cool
down and ensure space
for the air to circulate.
Switch on the appliance
only when the tempera-
ture of the appliance
and the surroundings
has fallen.
EN 17
Publicidad
