Beem Air Joy Hot&Cool Manual De Instrucciones página 19

BEEM - Elements of Lifestyle
NOTE
► The appliance continues to run for
roughly 10 seconds after switching off.
► Wait until the appliance has come to a
complete standstill before switching off at
the main switch and pulling the mains plug
out.
Setting the cold airflow
Continuous setting of the cold airflow takes
place via the regulator
trol panel (5). It is only possible to regulate
the cold airflow.
1. Switch on the appliance and the cold air-
flow as described above.
2. Turn the regulator
crease the airflow. The stronger the cold air-
flow is set, the more bars light up blue on the
control panel (5):
Setting the cold airflow
low airflow
medium airflow
maximum airflow
3. Turn the regulator
lower the airflow.
Warm airflow
Warm airflow CANNOT be set.
Only maximum hot air is produced and blown
out.
The 3 bars on the control panel light up red
ALWAYS.
NOTE
► The appliance is protected against
overheating. This switches off the appli-
ance to prevent overheating (see section
Safety equipment, page 14.
Switching the rotation movement
on/off
1. The rotating movement is switched on via
the button on the control panel (5).
2. Press the button again to switch off
the rotating movement.
button on the con-
clockwise to in-
Display
1 blue bar
2 blue bars
3 blue bars
anticlockwise to
Directing the airflow
The direction of the airflow is set via the incli-
nation adjustment on the foot (3).
NOTE
► Direct the airflow only when the appli-
ance is switched off.
► Carefully tilt the unit up to stop maxi-
mum in order to avoid damaging the unit.
1. Hold the foot tight with one hand.
2. Change the inclination of the appliance
with the other hand until the desired airflow
angle has been set.
Operating with the remote control
You can control all electrical functions of the
appliance with the remote control. Each push
of a button is acknowledged by a beep.
Symbol Function
Switching the appliance ON/OFF
-
Decrease cold airflow
+
Increase cold airflow
Switch warm airflow on/off
Switch rotation movement ON/OFF
Timer, 60 minutes
60
Timer, 120 minutes
120
NOTE
► Make sure that there is an an unob-
structed view between the appliance and
the remote control in order to control it with
the remote control.
► All settings made via the remote control
are confirmed by a beep.
EN 15