Srhythm SoulMate S2 Manual De Usuario página 5

b.Easy Pairing
Step �: Press and hold the Multi-function Button for � seconds to turn on the
Bluetooth earphone, then enter into pairing mode.
Step �: Keep the earphone and your phone as close as possible during pairing
process.
Step �: Turn on the Bluetooth on your phone. Search for the Bluetooth
earphone signal on your phone and click on "Srhythm S�" to pair.
Status LED Indicator Light
Turn On Blue light stays on for � second
Pairing Red and blue lights flash alternately
Paired Blue light flashes once every �S
Play /
Pause Blue light flashes once every �S
*Note:
The pairing mode will last for � minutes. If it is not connected to any device for more than � minutes,
the Bluetooth earphone will automatically turn off.
c. Pairing to the Second Bluetooth Device
Step �: Pair Srhythm S� with the First device via Bluetooth successfully and
then turn off the First device's Bluetooth.
Step �: Pair Srhythm S� with the Second device via Bluetooth.
Step �: Turn on Bluetooth of the First device and pair it with the earphone
again.
Now both of your devices are paired with Srhythm S� for easy switching.
�
d. Active Noise Cancelling (ANC)/Transparency Mode
After pairing the device, Click the ANC Button to switch between Transparency
mode, ANC mode, and Normal Mode .
Voice prompts
Power On
Pairing
Connected
/
/
e. Environmental Noise Cancelling (ENC) Mode
ENC is automatically activated when you're on a call or using your voice
assistant so that your voice can be heard more clear especially when you are in
the noisy environment.
f. Reset
Step �: Press and hold the Multi-Function Button for � seconds to turn on
Srhythm S� until the indicator light flashing red and blue alternately into
pairing mode(but not paired).
Step �: Press and hold "+" and "-" buttons at the same time for � seconds to
clear the pairing history, and try to connect again.
Status LED Indicator Light
Transparency Mode Blue light stays on
ANC On Blue light stays on
Normal Mode Blue light turns off
Status LED Indicator Light
Reset Red and blue lights flash alternately
�
Voice prompts
Transparency Mode
ANC On
ANC Off
Voice prompts
Beep
�