AEG NDP866PT Manual De Instrucciones página 45

change the light intensity in the following
order: Maximum, Medium, Low, Off.
To switch off the lights, touch and hold the
symbol for 3 seconds. Closing the drawer has
no effect on the hood light.
Setting the light colour temperature
The hood remembers the last setting of
the light intensity and colour temperature.
There are two ways to set the light colour
temperature:
1. Touch the symbol to change the
colour temperature from neutral, through
warm to cold.
2. Touch and hold the
smoothly between light colour
temperatures.
Release it once you reach the desired
setting.
AuroraTech
It is a function that automatically adjusts the
illumination colour and intensity based on the
time of day, creating an optimal ambiance.
Use the app to activate this function.
After activating from the app, the function
will operate each time the lighting is
switched on. You can still manually
adjust the lighting settings using the
and buttons. However, the
AuroraTech function will be deactivated.
3.2 Hob²Hood function
It is a function that connects the hob to a
hood. Both the hob and the hood are
equipped with an infrared signal
communicator. The fan speed is determined
based on the mode setting and the
temperature of the hottest cookware on the
hob. Alternatively, you can manually control
the fan using the hob. This function can be
activated from the hob's control panel.
symbol to move
45
If the hood drawer is closed, the
Hob²Hood will only activate the hood
light. The fan will remain off.
If the drawer is open, the function will
activate both the hood light and the fan.
For more information how to use the
function, refer to the hob user manual.
3.3 Filter notification
Filter alarm reminds to change or clean the
charcoal filter and clean the grease filter. The
symbol blinks regularly for 30 seconds if
the grease filter must be cleaned. The
symbol blinks twice per every second for 30
seconds if the charcoal filter must be
replaced.
This function activates independently
after 40 hours of operation for grease
filter and 160 hours of operation for
charcoal filter.
Refer to Cleaning the grease filter in the
Care and cleaning chapter.
Refer to Replacing the charcoal filter in
the Care and cleaning chapter.
The function counter for charcoal filter is
disabled by default. For recirculation
mode, it must be activated.
To activate or deactivate the counter for
charcoal filter:
1. Pull out the hood drawer.
2. Make sure the fan and the light are turned
off.
3. Touch symbol for 3 seconds.