AEG NDP866PT Manual De Instrucciones página 46

The function is activated if symbol
once. The function is deactivated if symbol
blinks twice.
To reset the function counter in the
notification period:
1. Pull out the hood drawer.
2. Touch symbol for 3 seconds.
The symbol stops blinking for the correct
reset.
3.4 WiFi connectivity setup
This feature enables you to connect your
appliance to a WiFi network and pair it with
your mobile device. Using this feature, you
can access additional functions, control and
monitor your appliance from your mobile
device, and receive notifications.
To connect the appliance you need:
• Wireless network with the Internet
connection,
• Mobile device connected to your wireless
network.
Frequency/Protocol
Power
Encryption
Installing the app
Take the following steps to connect the
appliance to WiFi :
1. Make sure that the appliance is plugged
into a power socket and turned on.
2. Make sure that your mobile device is
connected to the same wireless network
you want to add your appliance to.
3. To download the app, use your mobile
device's camera to scan the QR code
located on the back cover of the user
manual. You can also download the app
directly from Google Play (Android) or
App Store (iOS).
4. Open the app and register to create an
account.
blinks
WiFi: 2.4 GHz / 802.11
bgn
WiFi 2.4 GHz: <20 dBm
WPA-PSK, WPA2-PSK,
WPA3-SAE
Configuring the appliance wireless
connection
The onboarding is possible only for 20
seconds after activating the control
panel. If the
deactivate and activate the control panel
again.
Follow the instructions in the app to complete
the onboarding process:
1. Pull out the hood drawer. Make sure the
fan and the lighting are turned off.
2. Touch and hold the
appliance for 3 seconds, the
starts to flash continuously. The
onboarding process is ongoing.
3. Continue to follow the instructions in the
app to complete the onboarding process.
To stop the onboarding process, touch
the or any of the speed level symbols.
After the successful onboarding, the
appliance emits a single beep, and the
indicator stops flashing and becomes steady.
If the onboarding process is unsuccessful, the
indicator flashes rapidly for 6 seconds and
then turns off. Repeat the procedure.
If the onboarding process exceeds 1
minute, the control panel enters standby
mode, the indicator turns off, and the
app provides feedback on the onboarding
status.
After onboarding, the
visible once the control panel is activated
and a connection to the internet is
established.
Each time the action is performed using
the app, the
46
symbol turns off,
symbol on your
symbol is
indicator blinks 3 times.
symbol