DeLonghi MAGNIFICA EVO ECAM29.6 EX:2 Serie Instrucciones De Uso página 21

15. Immerse the infuser in water for about 5 minutes, then
rinse under the tap;
Important!
RINSE WITH WATER ONLY
NO DETERGENTS - NO DISHWASHER
16. Do not use detergents when cleaning the infuser, as they
could damage it.
17. Use a brush to remove any coffee residues left in the infus-
er housing, which can be seen through the infuser door;
18. After cleaning, replace the infuser by sliding it into its housing,
then apply pressure to the PUSH symbol until it clicks into place;
Please note:
If the infuser proves difficult to insert, adapt it (before inser-
tion) to the right position by pressing the two levers (fig. 40).
40
19. Once inserted, make sure the two colored buttons have
snapped out (fig. 41);
20. Close the infuser door;
21. Put the water tank back.
19. DESCALING
• Before use, read the instructions and the labeling on the
descaler pack.
• Use only descaler supplied by De'Longhi. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer's guarantee.
• Descaler can cause damage to delicate surfaces. If the
product is accidentally spilt, dry immediately.
38
To descale
Descaler
Container
Time
Accessory
Important:
If the water softener filter is installed, it must be re-
39
moved before adding the descaler solution.
Thereafter, reinstate the filter at the start of step 3
Descale the machine when the
control panel (C4). This same indicator will blink while the des-
cale cycle is in progress.
Please note:
• Once the descaling cycle has begun, it cannot be inter-
rupted and must be concluded with the full rinse cycle.
With this in mind, make sure there is sufficient descaler.
Proceed as follows:
1. Make certain that the water spout (D5) is fitted;
Step 1: Descaling
action
2. Press the
onds, until the relative Led starts blinking rapidly. The
mild intensity Led lights up to indicate that step 1 of the
descale cycle is in progress;
3. Empty the drip tray (A14) and the grounds container
(A10) and reposition them; empty the water tank com-
pletely (A9) and remove the softener filter (if installed);
4. Pour the descaler into the tank, filling to level A (which
corresponds to a 100ml pack) marked on the side (back) of
the tank (fig. 42); next, add water (one liter) up to level B
(fig. 43); finally, reposition the water tank in the machine;
41
B
A
5. Place an empty container of at least 2 litres capacity under the
coffee spouts (A17) and the water spout (D5) (fig. 44).
21
De'Longhi descaler
Recommended capacity: 2l
~30min
Hot water spout (D5)
indicator lights up on the
button (B5) and hold for at least 5 sec-
B
A
42 43