Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 030 9904733
Fig.1
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the
power cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician
or a person with similar qualifications, in order to avoid any risk.
Before each use, make sure the electric cord is in good condition.
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed with the selector (8).
1– Minimum speed 2–Medium speed 3–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the socket.
Horizontal oscillation (right-left): this is selected with the button (2) located on the motor body.
To stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and orienting it in the
direction desired.
When not in use for long periods, the plug must always be removed from the socket.
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
• Ensure that the fan is switched off from the supply mains before removing the guard.
• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not put your
hand in the liquid, but first remove the plug from the socket. Carefully dry the appliance and
make sure that all the electrical parts are dry: in the case of doubt, ask for professionally qualified
help.
• It is essential that the motor's air holes be kept from dust and lint.
• Periodically check the electric cord for damage; its replacement requires a special tool: contact an
authorized service center, also for any repairs.
• If the fan will not be used for long periods, it must be protected from dust and humidity; we
recommend storing it in its original packaging.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
8
24
/
Assembly page 8/16
1.
Motor shaft
2.
Oscillation button
3.
Body
4.
Pole attachment ring nut
5.
Cover
6.
Feet attachment screw
7.
Foot
8.
Selectors
9.
Fixed pole
10. Adjustable pole
11. Handle
12. Front grille
13. Fan attachment ring nut
14. Screw for the plastic ring
15. Grille attachment ring nut
16. Rear grille
17. Fan
18. Screw
Publicidad
