Environmental Protection; Faults; Trouble Shooting - Elektra Beckum WIG 170 DC Manual De Uso

9. Environmental Protection

The machine's packaging can be 100 %
recycled.
Worn out power tools and accessories
contain considerable amounts of valua-
ble raw and rubber materials, which can
be recycled.
These instructions are printed on chlo-
rine-free bleached paper.

10. Faults

In case of faults, error messages are dis-
played on the display to help identify the
source of the error.
Simultaneously the Fault LED is perma-
nently lit.
E02
Excess transformer temperature.
− The Excess temperature LED is lit.
− DO NOT switch machine OFF,
in order for the fan to cool the
machine down faster.
− If the temperature has fallen off to
normal levels, the display will show
the welding current again.
You may now continue welding.
E03
The lead to the transformer's tempera-
ture sensor may be broken.
E04
Possible short in the transformer's tem-
perature sensor lead.
E06
The machine's control has detected a
supply voltage of more than 20% below
the rated voltage.
To avoid excess primary currents the
machine shuts down.
3
Note:
This error message must be
acknowledged.
− Turn the machine OFF for 5 sec-
onds, then ON again.
If the error message appears again, turn
OFF and contact a qualified electrician!
E12
The arc did not start within 20 sec after
pressing the torch button.
− The machine shuts down.
− Release torch button.
The message is
machine is ready to operate again.
E14
Excess temperature of the primary sec-
tion.
E15
The lead to the primary section's temper-
ature sensor may be broken.
E16
Possible short in the primary section's
temperature sensor lead.
E17
Excess temperature of the secondary
section.
E18
The lead to the secondary section's tem-
perature sensor may be broken.
E19
Possible short in the secondary section's
temperature sensor lead.

11. Trouble Shooting

Brittle or porous weld seam
Gas valve
closed?
Gas cylinder
empty?
Unsuitable shield-
ing gas?
Gas line connec-
tion not tight?
Pressure regula-
tor faulty?
Gas shroud on
torch or torch
leads blocked?
Air draft at weld-
ing spot?
Workpiece not
clean?
Solenoid valve
faulty or dirty?
Welding return
cable making
poor contact?
Control PCB
faulty?
cleared, the
Supply circuit fuse
blown or cut-out?
Open gas valve.
Replace.
Use a suitable
shielding gas.
Check connec-
tions.
Check pressure
regulator.
Clean gas shroud.
Screen off weld-
ing spot or
increase gas flow
rate.
Remove rust,
grease or paint
coating.
Steady gas flow
Have solenoid
valve checked by
a qualified electri-
cian.
No welding current
Check welding
return cable for
proper contact.
Contact
service centre.
No function of machine
Replace or turn
ON again.
ENGLISH
13