Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
assembled.
Fan body:
• First loosen the two screws located on
the top part of the fan body, where the
downrod is going to be inserted.
• Remove the safety pin from the
downrod and save it. (Pic. 2)
• Then follow this sequence: Insert the
down rod through: the top cover and the
bottom cover (pic. 3)
• Introduce the cables through the down
rod too (Pic. 4)
• If you were unable to thread the cables
through the downrod we suggest that
you remove the hemisphere located on
top of the downrod (pic. 5), proceed as
follows:
• Remove the upper screws located
on the rubber hemisphere and save
them. Keep in mind that one of them
will hold the earth wire extension
cable (pic. 5.3) Remove the safety pin
and save it together with the screws
(pic. 5.2 and 5.1) Then thread the
cables and fix it again.
• To fix the hemisphere again: Insert
the safety pin in the holes on the top
part of the down rod (pic. 5.1) Then
bring up the rubber hemisphere until
all the holes are aligned (pic. 5.2)
Last, fix it with the screws you have
removed earlier and fix the earth
wire with one of them (pic 5.3)
• Once you have inserted the cables,
Fit the rod in the motor housing and
insert again the safety pin previously
removed. Then, tighten the screws of
the motor housing which have been
loosened before (pic. 6)
• Once you have finished, adjust the
bottom cover and hide the connection
between the down rod and the motor
housing. (Pic. 7)
How to assemble the LED light plate:
The LED light holder is supplied already
attached to the fan body. If your fan is
supplied with the two parts separately,
please follow the procedure below:
• Remove the three screws attached to
32
the bottom of the fan body and save
them together (fig. 8).
• Place the light plate so that the holes are
aligned with the holes for the screws
you have previously removed from the
light support and threading the cables
coming out from the motor through the
centre of the panel (pic. 9).
• Then fix the screws on the LED plate.
Please, make sure the lighting kit is
well fixed after you have tightened the
screws.
• The light receiver is supplied separately
and has a magnetic attachment. To
install it, attach it to the LED light
bracket so that it is magnetised and
proceed with the electrical connections.
Connect the two wires coming from the
motor to the two wires coming from
the LED light receiver. Then connect
the group of wires coming from the
receiver to the input you will see in the
centre of the LED light plate (Pic. 10).
Electrical connections:
• Put the fan on the ceiling bracket
by introducing the down rod in the
receiver bracket and turn it until you
hear a "click" sound, insert the slot
located on the hemisphere of the down
rod, in the tab of the receiver bracket.
(pic. 11).
• Then we can proceed to do the pertinent
electrical connections. See image 05 on
page 8:
• First place the receiver between the
bracket and the fan, with the smooth
part facing upwards (pic. 12).
• Once placed, connect the cables
coming out of the ceiling using the
circuit board located on the receiver
support. Connect the phase wire to
L and the neutral wire to N. Connect
the outgoing wires from the receiver
on the opposite side, matching the L
and N wires.
• Then connect the cables coming out
of the fan body to the cables coming
out of the receiver. Connect the earth
wires too (pic. 13).
Publicidad
