Publicidad
Idiomas disponibles
Idiomas disponibles
• Once the electrical connections are
completed, slide the top cover up
and align the holes with the screws
you have previously loosened on the
receiver support. Turn it until it fits and
then tighten the screws. (Pics. 14 and
15)
• Lastly, put the lamp cover. The cover
will be threaded to the light support.
Make the threads match the slight
creases on the support and turn it
clockwise until well fixed. Make sure it
is well fixed. (Pic. 16)
Once you have finished the installation
make sure the product works correctly. Pay
special attention to any strange oscillation
or malfunction in any of the fan parts.
In case the product shows any imbalance
or vibration, you can use the balancing kit
included to adjust it.
Remote control connection:
See picture 06 on page 8.
L : AC IN 220-240V
N : AC IN 220-240V
Blade balance kit:
Included in the purchased product you will
find a kit supplied to prevent the blades
from moving unbalanced.
The fan may wobble during functioning
due to an irregularity in the blades or
blade support. Also, improper installation
or an inclined angle can cause additional
problems.
It is recommended to follow the next
procedure to solve any of these problems :
• Turn the fan on and change the speed
until the most noticeable swing occurs
(usually the highest speed).
• Turn off the fan. Select a point between
each blade and place the two balancing
clips.
• Turn the fan back on and see if the tilt
has improved or worsened. Switch off
the fan and move the clips to another
zone between the following blades to
check again. Repeat this process for
all blades and note which zone has the
most noticeable improvement.
• Put the clip back on the zone where
you noticed the greatest improvement.
Move the clip along the blade and turn
on the fan to find the position where the
clip offers the better improvement.
• Next, remove the clip and place one of
the balance weights on the point where
the clip was placed. To do so separate
the white sticker with your fingernails
or, if necessary, carefully use a knife or
scissors.
• Make sure the problem has been solved.
If the imbalance persists, repeat the
process. You can use light weights on
those blades that may need it.
USING THE APPLIANCE
This device is very easy to use and does
not require much knowledge. However, we
advise you to familiarize yourself with the
instructions below.
The fan has 6 power levels that can be
selected through the remote control. It also
has a timer of up to 4 hours.
Remote control:
See picture 07 on page 9.
The device incorporates a remote control,
for a more comfortable and efficient use.
In order for the remote control to work, it
must always be aimed at the fan.
Before you start using it, please take a few
minutes to familiarize yourself with the
functions:
10. Total OFF button: Press it to turn the
device off.
11. Light ON/OFF button: Press it to turn
on the lights of the device. Press it as
many times as necessary to select
among the different colours of light,
with a choice of three options.
12. Summer mode: Press to operate the
fan in summer mode, which means
the fan blades rotate clockwise.
13. Natural wind mode: press to activate
EN
33
Publicidad
