Disposal Of Product; Compliance With Ce Regulations; Installing The Radio Receiver - Favero Electronics FOS2 Manual De Uso

1.6. Guarantee
The guarantee is valid for two years starting from the date of purchase and includes free repair for any defects in
materials or construction. The guarantee does not include shipping costs. Batteries are not included in the
warranty. More information on guarantee and post-sale support can be found at www.favero.com.
1.7.

Disposal of product

Please dispose of your product in a manner most compatible with the environment and in accordance with federal
or state laws, reusing parts and recycling components and materials when possible.
When this crossed-out waste bin symbol is attached to a product it signifies the product should be disposed of in a
separate container from other waste.
The sorted waste collection of the present device is organized and managed by the manufacturer. Users who wish
to dispose of their present device should contact the manufacturer and follow the procedure indicated for separate
waste collection.
Ensuring proper sorted waste collection, in accordance with environmental standards, for the disposal of further
devices helps to protect the environment and the health of persons from any damaging effects. It also favors the
reuse and recycling of materials.
Administrative sanctions, in accordance with regulations in effect, will be applied for any improper or abusive
disposal of the product on part of the holder.
Battery replacement: the internal lithium battery must be replaced by a qualified technician and recycled or
disposed of separately from household waste.
1.8.

Compliance with CE regulations

The product meets the essential requirements of the Electromagnetic Compatibility and Safety for electronic
devices, in accordance with European directives:
• 1999/5/CE of 9 March 1999,
• 2004/108/CE of 15 December 2004,
• 2006/95/CE of 12 December 2006.
For the USA:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy, and if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
To satisfy FCC RF exposure requirements for mobile and base station transmission devices, a separation distance of 20 cm or more
should be maintained between the antenna of this device and persons during operation. To ensure compliance, operation at closer
than this distance is not recommended.
The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
For the Canada:
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1)
this device may not cause interference, and (2) this device must accept any interference, including interference that may cause
undesired operation of the device.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser)
gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its
gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful
communication.
2. I
NSTALLING THE
Before installing the Radio Receiver, we suggest first running a preliminary test by temporarily connecting the
Radio Receiver to the scoreboard (see chapter 3.1).
F E
AVERO LECTRONICS SRL
R R
ADIO ECEIVER
3 / 26
00302-M01-03-ML - FOS2 Radio Receiver Installation Manual
ENGLISH