Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROLS
AKALELEC UC COT 1D.
MooEL NO. ANM-URIO
MAGE IN JAPAN
POWER Switch
Depress to turn on the power and depress again to turn off the
power.
oar
only the upper part of the switch (near the word POW-
ER).
Headphone Jack (PHONES)
Accommodates
8 ohm
low impedance type stereo headphones for
monitoring or private headphone listening.
Tone Controls
*
Set to DEFEAT
for flat frequency response with no tone con-
trol effect.
BASS:
For low range frequency response control. Can be ad-
justed from —8 dB to +8 dB.
TREBLE:
For high
range
frequency
response
control.
Can be
adjusted from —8 dB to +8 dB.
SPEAKERS Switch
.
Turn
on
(the SPEAKERS
indicator will light) the switch when
listening through speakers connected to the rear panel SPEAKER
terminals.
Turn off (the SPEAKERS
indicator will go out) the switch when
listening through headphones.
SPEAKERS Indicator
Will light when the SPEAKERS switch is turned on.
TAPE Switch with Indicator
Turn on (the indicator will light) the switch to monitor playback
of tape recorder or deck connected to the rear panel TAPE system
terminals.
Turn off (the indicator will go out) the switch to monitor source
signals.
Input Selector Switches with Indicators
1) AUX:
Depress for input from
a tape deck or crystal or ce-
ramic
type
cartridge
turntable
or
other
external
source
connected
to the rear panel AUX
jacks (the
indicator will light).
Depress for input from a tuner connected to the rear
panel TUNER
jacks (the indicator will light).
Depress
for
input
from
a magnetic
type
cartridge
turntable
connect.
to the rear panel PHONO
jacks
(the indicator will light).
FLD POWER Indicator
Indicates the output level for both left and right channels.
Stereo BALANCE
Control
For left and right speaker balance. Turning clockwise reduces the
volume of the left channel and turning counterclockwise reduces
the volume of the right channel. Output of left and right channels
is equal when set to the center click position.
2) TUNER:
3) PHONO:
10.
11.
12.
13.
14,
15.
16.
17.
18.
19.
LOUDNESS Switch
When
listening at a low volume
level, the range audible by the
human
ear is limited. The loudness circuit supplements this range
by boosting
the bass and treble response.
Depress for balanced
sound at low volume.
VOLUME
Control
For volume adjustment. Turn clockwise to increase volume.
Ground Terminal (7+7)
Connect
to the Ground
terminal
of turntables,
tape decks, etc.
*
When
connecting a turntable connect the ground wire to the
Ground terminal.
SPEAKER
Terminals (RIGHT and LEFT)
Accommodate speakers of 4 to 16 ohm impedance.
AC OUTLETS
(Some models are not equipped with this facility.)
UNSWITCHED
Outlet:
Not inter-connected with the front panel
POWER
switch. Power
is supplied even
when
the AM-U210
is turned off.
300W MAX.
SWITCHED
Outlets:
inter-connected
with
the
POWER
switch. Power
is cut when
the
AM-U210 is turned
off. TOTAL
200W
MAX.
front
panel
PHONO Jacks
Connect to the outputs of magnetic type cartridge turntable.
*
Use AUX jacks for connection of crystal or ceramic type car-
tridge turntable.
TUNER Jacks
Connect to the outputs of tuner.
AUX Jacks
For connection
of relatively high output components
such as a
crystal or ceramic type cartridge turntable or a tape deck or re-
corder.
TAPE System REC/PLAY Jacks
For connection
to a tape deck
or recorder for recording/play-
back.
REC:
Connects to the inputs of tape deck for recording.
PLAY:
Connects to the outputs of tape deck for playback.
Power
Cord
(Some
models
are equipped
with an AC
inlet instead
of a power cord. Connect with an appropriate power cord.)
Publicidad
