Publicidad
Idiomas disponibles
Idiomas disponibles
LL—'716
,,-,====4==,4
,4
REPEAT/FM
M"DE/
T
\\..———
, —
"'c
Iml=ra
\
3-MODE EQUALIZER —
T-BASS
Y
QSOUND
~
STOP/MEMORY
~
m,
w
VOLUME
Press VOLUME A
or V.
The volume level is displayed
as a number from O to MAX (25).
The volume level is automatically
set to 14 if the power
is turned off when the volume level is set to 15 or more.
To display the volume level when a function other than
TAPE function is selected
Press VOLUME A
or V.
The volume level is displayed
for 4 seconds.
DISPLAY on the remote control is also available (except
CSD-ED37).
3-MODE
EQUALIZER
Press * 3-MODE EQUALIZER
until one of the indicators
lights up.
The equalizer mode changes to ROCK, POP, JAZZ or no
equalization,
cyclically.
ROCK - Emphasizes
the high and low range of music.
POP - Emphasizes
voice and midrange of music.
JAZZ - Emphasizes
the low range of music.
* or EQ on the remote control (except CSD-ED37)
T-BASS system
The T-BASS system enhances the realism of low-
frequency sound.
Press T-BASS and the T-BASS indicator lights up.
QSOUND
system
This system
provides
a rich, three
dimensional
sound
area
for stereo
sources.
You can enjoy
more enhanced
sound.
Press
QSOUND
and the QSOUND
indicator
lights
up.
At higher volumes, turning QSOUND on may cause
sound distortion.
In this case, make the volume down.
The unit can be turned off automatically
at a specified time.
While CD function is selected, operate the following
procedures
in stop mode.
1
2
Press REPEAT/FM
MODE/OSC ~
while
pressing STOP/MEMORY 13'HW.
If STOP/MEMORY
is kept pressed, another operation
may start.
Within 4 seconds,
press l++
or M
to specify
the time until the power is turned off.
Each time it is pressed, the time changes between 10
and 90 minutes in 10-minute steps.
Specified time
While the sleep timer works,
the dot keeps flashing.
To check the time remaining
until the power is turned off
Repeat step 1 shown above.
The remaining time is
displayed for 4 seconds.
To cancel the sleep timer
Display the remaining time and press K
or ~
repeatedly
until OFF is displayed.
NOTE
If the
unit is turned off during tape playback, <-
or 4
on
the deck will not be released.
Press W=
to release
> or
4.
If an erroneous
display or malfunction
occurs
Make
sure that none of the deck operation
buttons is
pressed.
Press
while pressing POWER 0 STANDBY.
If the unit cannot be reset in the way above, disconnect
the
To listen with the headphones
AC cord and remove all the batteries to turn off the display.
Connect headphones
with a stereo mini plug to the 0 jack.
Leave the unit for a while and turn the power back on.
8
ENGLISH
Publicidad
