Fanimation SHOWROOM Serie Manual Del Usuario página 10

How to Assemble Your Light Kit (Continued)
3.
Remove one of the three screws in the housing
assembly. Retain the screw for later and slightly
loosen the remaining two screws. (Figure 3)
4. Securely attach 9-pin connector from the motor
assembly to wiring harness socket within LED kit.
(Figure 4)
WARNING
The color label on these two connectors must
correspond to each other.
5.
Assemble the LED kit to the housing assembly
using the two key slots. Replace the previously
removed screw and securely tighten all three screws.
(Figure 5)
CAUTION
The light source is designed for this specific
application and can overheat if serviced by untrained
personnel. If any servicing is required, the product
should be returned to an authorized service facility
for examination or repair.
Housing
Assembly
LED Kit
Motor Assembly
LED Kit
Housing
Assembly
10
Figure 3
Figure 4
Figure 5