Publicidad
Moving the machine when not in operation.
Roller version
The squeegee blades scrape the film of water and detergent from the floor and prepare the way for perfect drying.
With time, the constant rubbing makes the edge of the blade in contact with the floor rounded and cracked, re-
ducing the drying efficiency and requiring it to be replaced. The state of wear should be checked frequently. The
machine is fitted with two squeegees, for washing and drying when moving both forwards and backwards. The
squeegees feature a pressure adjustment system to adapt them to all types of surface. Pressure is adjusted by
turning the knob provided (Fig. E, ref. 14):
►
clockwise increases the pressure.
►
anticlockwise decreases the pressure.
To move the machine, proceed as follows:
►
lift the squeegee using the lever provided (Fig. D, ref. 2) for parabolic squeegee and "V" squeegee;
►
raise the front of the machine off the floor using the handle, then move it to the destination; if the tran-
sport wheel is fitted, lift the machine using the handle (standard on the roller version) so that it rests on
the wheel.
►
on arrival, lower the front of the machine.
Mounting and changing the brush/drive disks
Never work without the brushes and drive disks correctly installed.
Standard version with brushes and drive disks
Brush/drive disk attachment: turn the machine on by pressing the main switch (fig. C, ref. 3) (LED on), then press
the brush button (fig. C, ref. 4 (LED on). Rest the brush on the floor in front of the machine. Raise the front of
the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Operate the
brush lever (fig. D, ref. 1) repeatedly until the brush automatically engages on the flange hub. If the manoeuvre
is not successful, press on the handle again and repeat the centring and repeated operation of the brush lever.
Brush/drive disk release: turn the machine on by pressing the main switch (fig. C, ref. 3) (LED on), then press the
brush button (fig. C, ref. 4 (LED on).
Raise the front of the machine by levering on the handle, then operate the brush lever (fig. D, ref. 1) repeatedly.
After a few pulses, the brush (or drive disk) is released and falls to the ground.
Roller version
Attaching the brush roller:
►
switch the machine off, unplug the cable version from the power socket;
►
raise the front of the machine by hand;
►
with the other hand, insert the brush and push it upwards until it is correctly in position (Fig. P, ref. 1);
►
lower the machine
Releasing the brush roller:
►
switch the machine off, unplug the cable version from the power socket;
►
raise the front of the machine by hand;
►
with the other, remove the brush by pulling it downwards (Fig. P, ref. 1);
►
lower the machine.
Detergents - Instructions
Always dilute the detergent according to the manufacturer's instructions. Do not use sodium hypochlori-
te (bleach) or other oxidants, particularly in strong concentrations. Do not use solvents or hydrocarbons.
The temperature of the water and detergent must not exceed the maximum indicated in the technical
specification. They must be free of sand and/or other impurities.
The machine has been designed for use with low-foam biodegradable detergents made specifically for scrubber
driers.
For a complete and up-to-date list of the detergents and chemicals available, contact the Manufacturer.
Use products suitable for the floor and dirt to be removed only.
Follow the safety regulations on use of detergents given in the section "Safety regulations".
IMPORTANT
IMPORTANT
GB
27
Publicidad
