Publicidad
Idiomas disponibles
Idiomas disponibles
softener to proper time of day and then plug in.
BLOWN FUSE
Check the house fuse or circuit breaker panel. Replace a blownout
fuse or reset an open circuit breaker. Consult a registered
electrician when dealing with any electrical
POWER FAILURE
Any interruption in your power supply, or time changes, such as
daylight savings, will disrupt your softener's recharge schedule by
causing the timer to run off schedule. Reset time to the correct time
of day.
SALT SUPPLY
Check it. Refill if necessary and wait approximately four hours for
the salt to dissolve before initiating a recharge cycle.
INCREASED USAGE
Guests, family additions, new waterusing appliances, etc. all will
result in more water usage and will require more capacity from your
softener. You can reprogram your recharging schedule by following
the directions on adjustments for your softener in this manual.
NO WATER
If you aren't getting any waterflow at all, make sure your water
supply is working. Open a tap ahead of the softener (outside tap) to
see if you have any water pressure.
CONTINUOUS FLOW TO DRAIN
If water runs to drain continuously. Check to make sure unit is not in
regeneration. If it is regenerating, allow unit to finish cycle, and then
reset time of day if necessary. If the unit is not in regeneration,
contact Water2buy.
SALT BRIDGING
Salt "bridging" occurs when a gap has formed between the salt and
the water preventing the salt from dissolving in the water to make
brine. No brine = no soft water. High humidity and/or use of some
brands of purified salt products may cause a salt bridge to form.
The best way to check and eliminate a salt bridging problem is to
Publicidad
