Water2Buy W2B 110 Manual De Instrucciones página 32

DANGER: If your unit should freeze, do not attempt to disassemble
it. Contact Water2buy.com
The timer is very accurate. Keep setting correct to assure
recharging at the proper time.
A periodic clean out of the Salt Storage Tank is necessary to keep
your Water2buy Water Softener at peak operating efficiency. Do it at
least every 2 years when the salt supply is low. Follow these step­
by­step procedures:
Remove the salt storage tank cover and the cap from the brine
valve chamber.
If you'd like to save any clean, dry salt remaining in the tank,
remove it and place it in a clean container.
Using a scoop, dig out and discard as much remaining salt, water
and debris as possible.
Lay the salt tank on its side and direct a brisk stream of water from
your garden hose to its inside to rinse out all residue.
Using a household scrub brush and a mild soapy solution, clean the
salt plate. This will complete the tank cleaning.
Fill the salt storage tank with 10­15cm of water.
Fill the tank with salt to within a few cm's from the top.
The technology upon which the control valve is based is well
established and proven in service over many years.
However, should a problem or question arise regarding the
operation please refer to table below.
IMPORTANT: Service procedures that require the water pressure to
be removed from the system are marked with a !after the possible
cause.