Publicidad
Idiomas disponibles
Idiomas disponibles
a hammer; tap lightly across the mounting surface to
‒
find a solid sound
Place a mark halfway between the edges of the wall
2.
studs and draw a line down the center of the studs.See
possible wallstuds configuration. → Page 11
Possible wall stud configurations
These depictions show examples of preferred installation
configurations with the mounting plate.
No wall studs at corner holes
If the wall stud is within 6¼" (159 mm) of the vertical
center line, only room venting (recirculation) or roof
venting installations can be done.
Wall studs at one corner holes
No wall studs at both corner holes
7.3 Preparing the rear wall
Make sure the cabinet bottom is level.
1.
Draw a vertical line on the wall at the center of the
2.
cabinet space.
For cabinet with front overhang: Draw a line on the
3.
back wall equal to the depth of the front overhang.
Tape the REAR WALL TEMPLATE onto the wall
4.
matching the centerline and touching the bottom of the
cabinet or the level line.
Draw a horizontal line on the wall at the bottom of the
5.
REAR WALL TEMPLATE.
Drill holes at locations A and B on the REAR WALL
6.
TEMPLATE:
– ³⁄₁₆" (5 mm) holes for wood screws (stud)
– ⅝" (16 mm) holes for toggle bolts (no stud)
If neither A nor B is in a stud, find a stud somewhere in
the area of the mounting plate and drill a ³⁄₁₆" (5 mm)
hole.
It is important to use at least one wood screw mounted
firmly in a stud to support the weight of the appliance.
7.
CAUTION Wall venting installation:
If the exhaust adaptor is positioned outside consider
▶
the recommended dimensions, otherwise grease-
laden air will discharge into the house structure.
Wall venting installation only: Cut out the shaded
area F on the REAR WALL TEMPLATE using a saber
or keyhole saw.
Remove the REAR WALL TEMPLATE.
8.
7.4 Attaching the mounting plate to the wall
Remove the toggle wings from the bolts.
1.
Installation procedure en-us
11
Publicidad
