Descargar Imprimir esta página

Bosch HMV3054U Instrucciones De Instalación página 6

Ocultar thumbs Ver también para HMV3054U:

Publicidad

Idiomas disponibles

Idiomas disponibles

en-us
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE
If there is any doubt as to whether the wall receptacle is
properly grounded, the customer should have it
checked by a qualified electrician.
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
2.7 GROUNDING INSTRUCTIONS
This appliance must be grounded. Grounding reduces the
risk of electric shock by providing a safe pathway for
electric current in the event of a short circuit.
This appliance must be grounded. Connect only to
properly grounded outlet.
→  "Electrical installation - GROUNDING
INSTRUCTIONS", Page 10
WARNING
IMPROPER GROUNDING CAN RESULT IN A RISK OF
ELECTRIC SHOCK
Consult a qualified electrician if the grounding
instructions are not completely understood, or if doubt
exists as to whether the appliance is properly
grounded.
DO NOT USE AN EXTENSION CORD.
If the power supply cord is too short, have a qualified
electrician install an outlet near the appliance.
This appliance is equipped with a cord having a grounding
wire with a grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded.
2.8 Microwave safety
PRECAUTIONS TO BE OBSERVED BEFORE AND
DURING SERVICING TO AVOID POSSIBLE EXPOSURE
TO EXCESSIVE MICROWAVE ENERGY
¡ Do not operate or allow the appliance to be operated
with the door open.
¡ Make the following safety checks on all appliances to
be serviced before activating the magnetron or other
microwave source, and make repairs as necessary:
– Interlock operation
– Proper door closing
– Seal and sealing surfaces (arcing, wear, and other
damage)
– Damage to or loosening of hinges and latches
– Evidence of dropping or abuse
6
¡ Before turning on microwave power for any service test
or inspection within the microwave generating
compartments, check the magnetron, wave guide or
transmission line, and cavity for proper alignment,
integrity, and connection.
¡ Any damaged or misadjusted components in the
interlock, monitor, door seal, and microwave generation
and transmission systems shall be repaired, replaced,
or adjusted by procedures described in this manual
before the appliance is released to the owner.
¡ A microwave leakage check to verify compliance with
the Federal Performance Standard should be
performed on each appliance prior to release to the
owner.
2.9 State of California Proposition 65
Warnings
This product may contain a chemical known to the State
of California, which can cause cancer or reproductive
harm. Therefore, the packaging of your product may bear
the following label as required by California:
SAVE THESE INSTRUCTIONS.

Publicidad

loading

Este manual también es adecuado para:

Hmv3054c