Publicidad
Idiomas disponibles
Idiomas disponibles
3 Checklist for installation
Checklist for installation
Use this checklist to verify that you have completed each
Checklist for installation
step of the installation process. This can help you avoid
common mistakes.
Refer to detailed instructions for each step in the sections
following this checklist. Always read and follow the
complete installation instructions contained in this manual.
Before installing the appliance, be sure to verify the
cabinet dimensions are correct for your appliance
and that the required electrical connections are
present. Make sure the electrical cord provided on
the appliance is able to reach to the point of
connection.
→ "Location requirements", Page 8
→ "Electrical installation - GROUNDING
INSTRUCTIONS", Page 10
Move the appliance into place in front of the
cabinet opening.
Remove packaging materials, leaving the bottom
packaging on the appliance to avoid damage to the
floor.
→ "Removing packaging", Page 7
Remove the mounting plate from the rear of the
appliance.
→ "Removing the mounting plate", Page 10
Find wall studs.
→ "Finding the wall studs", Page 10
Attach the mounting plate to the wall.
→ "Attaching the mounting plate to the wall",
Page 11
Adapt the microwave blower.
→ "Adapting the microwave blower", Page 12
Prepare the cabinet for mounting.
→ "Preparing the cabinet", Page 14
At least two persons are needed to lift the
appliance; tilt and hook the appliance to the holding
plate.
→ "Mounting the appliance", Page 14
Push the appliance all the way into place and
fasten the holding screws through top cabinet
holes.
→ "Mounting the appliance", Page 14
Use correct hood exhaust.
→ "Hood exhaust", Page 15
Test the appliance for proper functioning.
4 Before you begin
Before you begin
Read these instructions before you begin to install your
Before you begin
appliance.
All graphics are representative. Your appliance may vary
in appearance and features.
4.1 Removing packaging
NOTICE:
To avoid damage to the appliance, do not grip or use the
door or door handle while the appliance is being moved.
Remove filters, accessories and hardware. Do not
1.
remove the packaging protecting the front of the
appliance.
Fold back all four carton flaps fully against carton sides.
2.
Carefully roll the appliance and carton over onto the top
3.
side. The appliance should be resting in the Styrofoam.
Pull the carton up and off the appliance.
4.
Cut the middle of the outer protective plastic bag to
5.
remove the mounting plate.
4.2 Parts included
After unpacking all the parts, check for any damage in
transit and for completeness of delivery.
A
Top mounting bolts:
Self-aligning machine screws ¼" - 28 x 3¼"
B
Toggle bolts - ³⁄₁₆" x 3"
C
Wall mounting hardware:
Toggle wings
D
Wood screws ¼" x 2"
Checklist for installation en-us
7
Publicidad
