Descargar Imprimir esta página

Joie i-Pivot 360 Manual De Instrucciones página 10

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 41
Base Installation
see images
-
9
15
1. Insert ISOFIX guides to assist with installation.
2. Press the ISOFIX adjuster button to extend the ISOFIX.
3. Make sure that both ISOFIX connectors are securely attached to
their ISOFIX anchor points. The colors of the indicators on both
ISOFIX connectors should be completely green.
!
Press the ISOFIX adjustment buttons again while pushing the seat
back until it comes in contact with the vehicle seat backrest.
4. After attaching the ISOFIX, pull the load leg downward to floor. When
the load leg indicator shows green, the load leg is installed correctly.
-2
12
5. Squeeze the load leg releasing button, then adjust the load leg
length.
-3
12
!
Always make sure the support leg has direct contact with the floor
and is in locked position even when the child is not in it.
Removing the seat
1. To remove from the vehicle press the ISOFIX adjuster button and pull
the base back from the seat. Then press and release the connectors
from the vehicle's ISOFIX.
2. To prevent damage during transit, press the ISOFIX adjuster button
15
-1
and fold the connector completely.
9
9
11
-1
12
14
15
-2
Using in the rear facing mode
(Child height 40cm-105cm/Child weight
21kg/infant - 4 years old)
see images
-1&
-2
11
!
Install the enhanced child restraint on the rear vehicle seat, and then
place the child in the enhanced child restraint.
Press the rotating button to rotate for easier side loading/unloading of
the child, then rotate the seat to the rear facing position.
!
Press the rotating button on either side to rotate the enhanced child
restraint.
Securing Child
1. To lengthen the shoulder harness belts, press the harness
adjustment button while pulling out the shoulder harnesses to
loosen.
2. Unbuckle the harness by pressing the red button.
3. Fix the buckles on the both sides of the seat shown as
located on the both sides of seat to make placing the child in rear
facing mode more convenient.
Use Infant Insert
-
16
23
18
We recommend using the full infant insert while the
baby is under 60cm and can be used until they
outgrow the infant insert. The infant insert increases
side impact protection.
&
16
17
19
which
20
10

Publicidad

loading