Publicidad
Idiomas disponibles
Idiomas disponibles
I I_[-.'_1 Iv;_ II Ir;'ul[o_J
HOW TO SET UP YOUR
UNIT
Location
of the Air Compressor
Locate the air compressor
in a clean,
dry and well ventilated area. The air
compressor should be located at
least 12" away from the wall or other
obstructions
that will interfere with
the flow of air. The air compressor
pump and shroud are designed to
allow for proper cooling. The
ventilation openings on the
compressor are necessary to
maintain proper operating
temperature.
Do not place rags or
other containers on or near these
openings.The
air filter must be kept
clear of obstructions
which could
reduce air flow to the air compressor.
GROUNDING
INSTRUCTIONS
Risk of Electrical
Shock.
In the event
of a short circuit, grounding
reduces the risk of shock by
providing an escape wire for the
electric current. This air
compressor must be properly
grounded.
The portable air compressor
is
equipped with a cord having a
grounding wire with an appropriate
grounding
plug (see following
illustrations).
The plug must be used
with an outlet that has been installed
and grounded in accordance
with all
local codes and ordinances.
1.
The cord set and plug with this
unit contains a grounding
pin.
This plug MUST be used with a
grounded outlet.
IMPORTANT: The outlet being used
must be installed and grounded in
accordance
with all local codes and
ordinances.
2.
Make sure the outlet being used
has the same configuration
as
the grounded plug. DO NOT
USE AN ADAPTER. See
illustration.
1 _lu_j
_Grounded
_
l_
Outlets
Grou_ d_ing Pin
3.
Inspect the plug and cord before
each use. Do not use if there are
signs of damage.
4.
If these grounding instructions
are not completely
understood,
or if in doubt as to whether the
compressor
is properly
grounded, have the installation
checked by a qualified
electrician.
I_'J_'_
Risk of Electrical
Shock. Improper
grounding can result in electrical
shock.
Do not modify the plug provided. If
it does not fit the available
outlet, a
correct outlet should be installed
by a qualified electrician.
Repairs to the cord set or plug
MUST be made by a qualified
electrician.
11_ ENG
D27312
Publicidad
