Publicidad
Idiomas disponibles
Idiomas disponibles
Problem
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no sound when
you touch the panel sensor
fields.
comes on.
comes on.
and a number come on. There is an error in the
You can hear a constant
beep noise.
8.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
Possible cause
Power management oper‐
ates.
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
Child Safety Device or
Lock operates.
There is no cookware on
the zone.
The cookware is unsuita‐
ble.
The diameter of the bottom
of the cookware is too
small for the zone.
hob.
The electrical connection is
incorrect.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
ENGLISH
Remedy
Refer to "Daily use".
Put large cookware on the
rear zones if possible.
Activate the sounds. Refer
to "Daily use".
Refer to "Daily use".
Put cookware on the zone.
Use suitable cookware.
Refer to "Hints and tips".
Use cookware with correct
dimensions. Refer to
"Technical data".
Deactivate the hob and ac‐
tivate it again after 30 sec‐
onds. If
comes on
again, disconnect the hob
from the electrical supply.
After 30 seconds, connect
the hob again. If the prob‐
lem continues, speak to an
Authorised Service Centre.
Disconnect the hob from
the electrical supply. Ask a
qualified electrician to
check the installation.
19
Publicidad
