Dea PASS Serie Instrucciones De Uso página 30

8.2 Learning
1. Scroll down the parameters with
keys until you visualise P005;
2. Confirm by pressing on the
3. When the symbol "
any key of the transmitter you want to mem-
orize;
4. The display visualizes the number of the
transmitter just memorized and then "
" flashing;
5. Memorize all necessary transmitters repeat-
ing this procedure from step 3;
6. Wait 10 seconds before quitting the memo-
rization mode, display shows now "----".
Warning: In the case of rolling code remotes,
the receiver can be put into learning mode
by pressing the hidden button on a remote
control previously learned.
9
Adjustment of operating parameters
If you need to modify the operating parameters, follow the proce-
dure below.
Warning: In order to ensure an optimum operation, the para-
meters given in the table must be set as indicated for the type
of barrier used.
1. Scroll down the parameters until you visualize the desire pa-
rameter (i.g. P032);
2. Confirm by pressing on the
3. By pressing on and
4. Confirm by pressing on the
eters previously selected).
For the complete list of the "Operating Parameters" See
the table on page. 34.
BOOM
PASS24NET/L (4 m)
PASS24NET/V (3 m)
PASS24NET/VR (4 m)
PASS24NET/L (5 m)
BOOM
PASSNET/L (4 m)
PASSNET/V (3 m)
PASSNET/VR (4 m)
PASSNET/L (5 m)
10
Programming complete
WARNING At the end of the programming procedure, use the buttons
operator is now ready again for new manoeuvres.
To perform any "Advanced Programming" operations (cancellation of the remotes, configuration inputs, etc. ..),
see on page 29.
28
and
key;
" flashes, press on
key;
, set up the desired value;
key (display shows the param-
Recommended values for standard "TYPE 03 - Barriers" 24V
Running speed Slowdown speed
(P032 - P033) (P034)
100% 30%
80% 30%
80% 30%
100% 30%
Recommended values for standard "TYPE 03 - Barriers" 230V
Running speed Slowdown speed
(P032 - P033) (P034)
100% 20%
90% 25%
80% 25%
100% 20%
Slowdown
Soft-start
duration
(P054)
(P035 - P036)
15% 0
20% 0
20% 0
15% 0
Slowdown
Soft-start
duration
(P054)
(P035 - P036)
15% 0
45% 0
45% 0
15% 0
and until the appearance of the symbol "----", the
Facilitation
Stop margin
release
(P058 - P059)
(P057)
2 10
1 3
1 3
2 10
Facilitation
Stop margin
release
(P058 - P059)
(P057)
2 10
2 15
2 5
2 10