Door Reversal
1. Close the cabinet and remove the
plug from the electrical socket.
2. Remove the ventilation grille. There
is a part on the grille that can be
removed. Remove and reposition it on
the other side.
3. Put the cabinet on a wooden board
when it is laid down. Later, when
raising the cabinet, it will be easier to
grip under the cabinet thanks to the
board.
1
2
3
4. Unscrew the three screws on the
backside of the front cover
Remove the front cover
4
Unscrew the hinge pin
Remove the door
5. Unscrew the door stopper screw
Remove the door stopper
5
6. Remove the two cover lids on the
roof
7. Unscrew the two screws on the
hinge
6
8. Remove the cover on the front
8
Reassembly in reverse order on the
opposite side.
Raise the cabinet and replace the
ventilation grille.
9. To transfer the handle.
Unscrew the screws. Fit the handle
onto the opposite side by turning it
one half circle. Press the supplied
plastic plugs into the holes to which
the handle was previously fitted.
9
Put the cabinet in position. Check that
the appliance is level. See the section
"Positioning the cabinet".
7
20