Alemite 7835-SDTR1 Guía De Servicio página 4

EMAIL: robert.collins@skf.com WEBSITE:
This U.K. Declaration of Incorporation is
issued under sole responsibility of the
manufacturer. Alemite, L.L.C. hereby
declares that the partly completed
machinery stated below:
Name:
Medium-pressure, compressed air pump
Model number(s): 7835-SDTR1
Description: Stainless grease pump
Year of CE: 2020
in its intended use, is in conformity with the
relevant union harmonization legislation:
Supply of Machinery (Safety) Regulations
2008 (S.I. 2008:159)
I, the undersigned of Alemite, L.L.C., hereby declare that the equipment specified above, in its intended use, conforms with the Essential
Health and Safety Requirements of U.K. legislation Supply of Machinery (Safety) Regulations 2008 No. 1597 Annex I, Declaration of
Incorporation by the time of placing it on the market.
___________________________________
Robert Collins
Technical Compliance Manager
St. Louis, MO, U.S.A.
2023/03/06
U.K. Declaration of Incorporation *
Manufacturer name/address:
Alemite, L.L.C.
167 Roweland Drive
Johnson City, TN 37601 U.S.A.
TEL: +1 (314) 679-4200 FAX: +1 (314) 679-4367
Authorized to compile the technical file:
SKF (U.K.) Limited
2 Canada Close
Banbury, Oxfordshire, OX16 2RT, GBR
along with the following Directive(s) that
were also applied with the above legislation:
EN ISO 4413: 2010
Hydraulic fluid power - general rules and
safety requirements for systems and their
components
EN ISO 12100: 2010
Safety of machinery. General principles
for design. Risk assessment and risk
reduction
EN ISO 809: 1998+A1:2009
Pumps and pump units for liquids -
common safety requirements
EN 12162: 2009
Liquid pumps - safety requirements -
procedure for hydrostatic testing
www.skf.com
The following EHSR (Essential Health and
Safety Requirements) have been applied:
1.1.2a – 1.1.2b – 1.1.2c – 1.1.3 – 1.1.5 –
1.3.2 – 1.3.3 – 1.3.7 – 1.5.3 – 1.5.8 –
1.5.13 - 1.7.1 – 1.7.1.1 –1.7.3 – 1.7.4
The manufacturer maintains a technical file
summary sheet containing test reports and
product documentation:
Technical file summary sheet number:
RA670653
The partly completed machinery shown
above should not be put into service until the
final machinery into which it is to be
incorporated has been declared in conformity
with the provisions of the directive, where
appropriate.
*
4
DOCUMENT NUMBER
UK670653CA
Indicates change.