RS Pro RSiLDM-30 Manual De Instrucciones página 4

Laser Distance Meter/English
Reference Level Setting (See "Figure D")
The default reference setting is taken from the rear of the instrument.
Press this button to take the selection from
MEM
edge, A special beep sounds whenever the reference setting
is changed. After a re-startup the reference returns automatically
to the default setting (rear reference).
O FF
Ui nt
M EM
Figure D
Distance Unit Setting For Instrument
Hold down the button longer to change the next type of
Ui nt
unit. The following unit can be set:
Distance Area
1 0.000 m 0.000 m²
0.0 in
2 0.000 ft²
0 1/16 in
3 0.000 ft²
4 0.000 ft
0.000 ft²
5
0'00" 1/ 6 0.000 ft²
4
4. Measuring
Single Distance Measurement
the front
Press to activate the laser.
Press again to trigger the distance measurement. The
measured value is displayed immediately.
Continuous Measurement (Tracking) & Max and Min Measurement
(See "Figure E")
The continuous measurement function (tracking) is used for
the transferring of measurements, e.g., from construction
plans. In continuous measurement mode, the measuring tool
can be moved to the target, whereby the measured value is
updated approx. every 0.5 seconds in the third line. The
corresponding minimum and maximum values
are displayed dynamically in the
O FF
first and second line.
Ui nt
M EM
As an example, the user can move from
a wall to the required distance,
while the actual distance can be
read continuously.
For continuous measurement, Hold down the
it will start the continuous measurement.
And press
again to stop the function. The
function is terminated
automatically after 100 continuous
Volume
measurements.
0.000 m³
The MIN and MAX data will
display in lines 1 and 2
0.000 ft³
individually.
0.000 ft³
0.000 ft³
0.000 ft³
Laser Distance Meter/English
or button
OFF
MIN
MAX
Figure E
button and
5