cecotec BOLERO HEXA MWO706000 LINE Manual De Instrucciones página 73

To avoid damage to different surfaces by using the wrong cleaning agent, please observe the
information in the table.
Warning, risk of surface damage, DO NOT use:
1. Abrasive or strong cleaning agents.
2. Cleaning agents with high alcohol content.
3. Sharp scouring pads or cleaning sponges.
4. High-pressure or steam cleaners.
5. Special cleaners to clean the device while it is hot.
Wash new sponge cloths thoroughly before using them.
Tip
Follow the manufacturer's instructions for cleaning and care products.
Exterior surface
Exterior surface
Stainless-steel
front part
Plastic
Coloured
surfaces
Control panel
Door panels
Cleaning
Hot water with soap:
Wipe it with a kitchen cloth and then dry it with a soft cloth.
Immediately remove lime, grease, starch, and albumen stains (e.g., egg
white).
Corrosion may form under these stains.
You can buy special cleaning products to clean stainless steel and
suitable for hot surfaces in specialised stores. Apply a very thin layer of
the cleaning agent with a soft cloth.
Hot water with soap:
Wipe it with a kitchen towel and then dry it with a soft cloth. Do not use
glass cleaner or a glass scraper.
Hot water with soap:
Wipe them with a kitchen towel and then dry them with a soft cloth.
Hot water with soap:
Wipe it with a kitchen towel and then dry it with a soft cloth. Do not use
glass cleaner or a glass scraper.
Hot water with soap:
Wipe it with a kitchen cloth and then dry it with a soft cloth.
Do not use a glass scraper or stainless-steel scouring pad.
BOLERO HEXA MWO706000 LINE
ENGLISH
73