Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
Before first use:
-
Remove all stickers, surface protection films and transport protection parts.
-
Remove every accessory and side racks from the interior.
-
Thoroughly clean the accessories and side racks with soap and water and a kitchen cloth
or a soft brush.
-
Make sure there are no packaging materials inside, as polystyrene pellets or pieces of
wood which may cause a fire hazard.
-
Clean all interior smooth surfaces and the door with a soft and damp cloth.
Keep your kitchen well ventilated while the device is heating for the first time. Keep children
and pet away from the kitchen during use. Close the door of the rooms next to it.
1. Plug the oven power cord into a mains socket.
2. Insert the baking tray and the rack.
3. Select
250 °C and heat up the oven while empty for 60 minutes.
Note: you may notice smoke and a burning smell at first. However, this does not affect the
safety or operation of the appliance.
When the oven cools down:
1.
Clean the flat surfaces and the door with water and soap and a kitchen cloth.
2.
Dry every surface.
3.
Install the side racks.
3. INSTALLATION
-
In order for the appliance to operate safely, it must be installed by a qualified professional
in accordance with the installation instructions and local regulations. Damage produced
by an incorrect installation are not covered by the warranty.
-
During installation, use protective gloves to prevent cuts with sharp edges.
-
Check the appliance for damage before installation, do not connect it to the mains if it is
damaged.
-
Before switching on the appliance, remove all packaging and adhesive film from the
product.
-
Figure 2 shows the dimensions (in mm) required for installation.
-
The plug must be accessible, or a switch must be incorporated in the fixed wiring, so that
the device can be disconnected from the supply after installation if necessary.
-
Warning: you should not install the device behind a decorative door to avoid overheating
the door.
1. Place the oven in the location you have selected, always making sure to comply with the
dimensions detailed in figure 2.
64
BOLERO HEXA MWO706000 LINE
Publicidad
