Ryobi ECS-1214N Manual De Utilización página 13

GB
F D
GENERAL SAFETY RULES
If devices are provided for the connection of dust
■
extraction andcollection facilities, ensure these
are connected and properly used. Use of these
devices can reduce dust related hazards.
POWER TOOL USE AND CARE
Do not force the power tool. Use the correct
■
power tool for your application. The correct power
tool will do the job better and safer at the rate for
which it was designed.
Do not use the power tool if the switch does not turn
■
it on and off. Any power tool that can not be controlled
with the switch is dangerous andmust be repaired.
Disconnect the plug from the power source
■
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of starting
the power tool accidentally.
Store idle power tools out of the reach of children
■
and do not allow persons unfamiliar with the
power tool or these instructions to operate the
power tool. Power tools are dangerous in the hands
of untrained users.
Maintain power tools. Check for misalignment or
■
bindling of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean. Properly
■
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
Use the power tool, accessories and tool bits etc.,
■
in accordance with these instructions and in the
manner intended for the particular type of power
tool, taking into account the working conditions
and the work to be performed. Use of the power
tool for operations different from intended could result
in a hazardous situation.
SERVICE
Have your power tool serviced by a qualified
■
repair person using only identical replacement
parts. This will ensure that the safety of the power
tool is maintained.
Check damaged parts. Before further use of the tool, a
■
guard or other part that is damaged should be carefully
checked to determine that it will operate properly and
perform its intended function.
E I P NL S DK N FIN GR
English
Check for alignment of moving parts, free running of
moving parts, breakage of parts, mounting and any
other part that is damaged should be properly repaired
or replaced by an authorized service center unless
otherwise indicated in this instruction manual. Have
defective switches replaced by an authorized service
facility. Do not use the tool if the switch does not turn it
on and off.
SPECIFIC SAFETY INSTRUCTIONS FOR
SANDERS
Always wear safety goggles and a dust mask
■
when sanding, especially sanding over-head.
The machine is not suitable for wet sanding.
■
Do not use sanding paper larger than needed.
■
Extra paper extending beyond the sanding pad can
also cause serious lacerations.
The dust bag shall be equipped with the tool.
■
And it shall be emptied frequently. To connect dust bag,
insert the adapter of dust bag to the dust-collection
opening on the rear end of the sander.
DESCRIPTION
1. Switch trigger
2. Quick Change Hook & Loop Pad
3. Dust Bag With Frame
4. Paper Punch
5. Sand Paper
6. Live Tool Indicator
SPECIFICATION
Voltage
Power
Orbital Minute
Weight
9
RO
H CZ RUS
WARNING
Do not throw sanding dust on an open fire because
materials in fine particle form may be explosive.
WARNING
A suitable breathing respirator must be worn
while sanding lead paint, some woods and metal
to avoid breathing the harmful/toxic dust or air.
HR
PL SLO TR
230 V ~ 50 Hz
120 W
12000 min
-1
1.28 kg