LG U10CS1C Manual Del Propietário página 21

(For the center of the product, refer to Product
Overview and Front.)
• Do not hold the product and rotate it forcibly.
• If you have forcibly rotated the product, the
center of the product should be reset.
• To align its center, turn the product off, unplug
it, wait a few minutes, and plug it back in.
When you use rotation, the product's center is
then initialized automatically.
• If you rotate the product manually, a noise may
occur during initial rotation.
- After the product rotates once, it will operate
normally.
Using the Extra Functions
Setting the Sleep Timer
Set the timer to turn the product off automatically
after a specific time.
• Press the Sleep Timer button during operation
to set the sleep timer in the order of 1H (turn off
1 hour later) ~ 12H (turn off 12 hours later)
OF (cancel)
NOTE
• When the sleep timer is set, the product stops
rotating and the display brightness is set to level
1. (However, if the display brightness is set to Off
before the sleep timer is set, the screen
brightness will remain OFF.)
• When the sleep timer is set, the fan speed is
automatically adjusted to maintain quieter
operation and avoid disturbing your sleep.
• You can change the fan speed, display
brightness, and rotation even while the sleep
timer is set.
• To cancel the sleep timer once it's set, press the
Sleep Timer button on the remote control once
again.
Setting the Standby Screen
The screen displays a variety of indoor air
information.
• Press the Information Display button on the
remote control to set the desired standby screen
in the order of Air Quality
PM1.0
~ ~
Humidity.
Standby
Screen
Information
Air Quality
~
PM10
PM2.5
PM1.0
Room
Temperature
OPERATION
PM10
~ ~
Room Temperature
~
Contents Example
Displays the
status of
overall air
quality.
Displays
PM10 (fine
dust)
information.
Displays
PM2.5 (ultra-
fine dust)
information.
Displays
PM1.0 (super
ultra-fine
dust)
information.
Displays
indoor
temperature
information.
21
PM2.5
Room