Publicidad
Idiomas disponibles
Idiomas disponibles
Pickup Bed Preparation and Installation
NOTE:
Read this entire section before drilling to reduce risk of damage to pickup bed.
1.
If removed, temporarily put pickup bed in place
•
Ensure the pickup bed is properly aligned to prevent misalignment of holes.
2.
ALTERNATE METHOD: Lift pickup bed and support with 4x4 blocks to provide clearance to install center rails
Using a 1/8" drill bit, drill 4 holes per the reference dimensions in Figure 9.
3.
4.
While under the vehicle, check alignment of the pilot holes with the installed cross rail Puck centers (item 1).
Adjust pilot hole positions as needed for proper alignment. It may be necessary to modify the exhaust heat shield
for proper fit.
Once you are satisfied with the 1/8" pilot holes, then drill 4 holes using the 3" hole saw. USE CAUTION WHEN
5.
DRILLING TO PREVENT BED DAMAGE.
6.
Deburr the rough edges of the 4 drilled holes.
7.
Apply corrosion preventative to raw edges of drilled holes.
8.
Remove 4x4 blocks and set truck bed onto the frame rails. Adjust bed alignment and install the bed bolts.
9.
Tighten the bed bolts to 50 ft-lbs (68 Nm).
INSIDE SURFACE OF
WHEEL WELL
Vehicle Forward
©
2022 Horizon Global
46-15/16" (1192.2mm)
16-3/16"
(410mm)
Page 6 of 24
30953N
30-13/16" (782.3mm)
FIGURE 9
12/05/22
C L
Rev. B
Publicidad
