Hinkley ATOM 906030FHB-LDA Manual De Instrucciones página 10

INSTALLING THE FAN IN THE DOWNROD CONFIGURATION
WARNING:
To Reduce The Risk Of Electric Shock, Disconnect
The Electrical Supply Circuit To The Fan Before Installation.
To properly install your ceiling fan, follow the steps below.
1 Remove ball from downrod by loosening set screw in the
side of the ball. Slide ball down and remove cross pin;
remove ball. (Fig. 1)
Carefully support fan body (motor) in its styrofoam packing
2
with the mounting collar (where the wires come out) facing
upward.
Loosen the two security set screws and remove the downrod
3
pin and cotter clip from the coupling on top of the motor
assembly. (Fig. 2)
4 Carefully feed the electrical lead wires and safety cable
from the fan through the downrod. Thread downrod into
coupler until holes align. Insert downrod pin through holes
in mounting collar and downrod; clip cotter pin through
small hole in end of downrod pin to hold downrod in place.
Tighten security set screws against downrod using a large
5
flat blade screwdriver to ensure a tight fit against downrod.
|
08
hinkley.com
Hanger ball
Fig. 1
Hook-up (3) wires
Downrod
Mounting collar
Security set
screws
Cotter
pin
Fig. 2
Cross pin
Set screw
Downrod
Safety cable
Downrod
pin
Security set
screws