Publicidad
Idiomas disponibles
Idiomas disponibles
CEILING CANOPY INSTALLATION
DOWNROD CONFIGURATION
1
Tuck connections neatly into ceiling outlet box.
Slide canopy up and fasten to hanger bracket with 4 screws
2
provided.
Raise up decorative ring and line up the 4 tabs with the 4
3
grooves on the canopy. Once lined up, slide the decorative
ring and secure it to the canopy until snug.
NOTE: Adjust the canopy screws as necessary until the
canopy and trim ring are snug.
HUGGER CONFIGURATION
Insert 2 screws into the hanger bracket, leaving them
1
partially out (Fig. 2).
2
Attach the canopy to the hanger bracket by inserting the
keyslot openings of the canopy on the hanger bracket
screws (Fig. 2), and turn the fan to the right to engage the
screws in the keyslot.
3
Insert the 2 remaining screws through the remaining
canopy holes and tighten all 4 screws.
Raise up decorative ring and line up the 4 tabs with the 4
4
grooves on the canopy. Once lined up, slide the decorative
ring and secure it to the canopy until snug.
Make sure the hook on the hanging bracket properly sits in the groove in the hanger ball before
attaching the canopy to the bracket by turning the housing until it drops into place.
Screws
Hanger
bracket
Canopy
Decorative Ring
Fig. 1
Screws
Hanger
bracket
Decorative Ring
Fig. 2
WARNING:
Ceiling fan
outlet box
Screws
Groove
Ceiling fan
outlet box
Screws
Canopy
| hinkley.com |
©2023 Hinkley Lighting, Inc.
11
Publicidad
