PLAYKIN RANGE ROVER DISCOVERY Manual Del Usuario página 37

2.4G REMOTE CONTROL
Forward
Back
Speed
indicator
light
ATTENTION: The remote control should only be used by adults.
NOTE: The remote control has priority over the pedal. (The pedal will not work while you
are using the remote control).
FEATURES
Supply Voltage: 2 X 1.5 V
Frequency: 2.4GHz
PAIRING I NSTRUCTION
1. Turn on the power of the rid e on car , press and hold the pairing button until the speed
indicator light switches on without flashing
2. Release the pairing button, and the speed indicator light will switch off
3. If the speed indicator light switches on again, then the pairing is successful; if not, please repeat
steps 1 and 2
4. One successful pairing is all, and no more pa irings are needed in later use
BATTERY INSTALLATION
Open the back cover of the remote control and insert two triple A batteries (AAA 1.5V). Please pay
attention to the polarity. Close the back cover and tighten the screws when the LED light is on, indicating
battery installed properly.
Battery needs to be replaced when the LED light dims or blinks.
Speed
Paring
Left
Break
37
Forward: Direct the rid e on
car to move forward.
Backward: Direct the rid e
on car to move backward.
Paring: Pair the rid e on car
Right
with a remote controller.
Left: Direct the rid e on car
to turn left.
Right: Direct the ride on car
to turn right.
Speed: Adjust the speed of
the rid e on car s movement
as low, moderate or high.
Brake: Immediately stop the
rid e on car and render it
immovable until unlocking.
EN