Diamond CARRELINO 3 Instalación Y Uso página 8

5. CONNECTION TO THE MAINS
1 . Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance. 2. Ensure that the supply socket has the following characteristics:
b)
earthed. It fulfils the requirements of the rated current as set out on the rating plate.
the IEC regulations: - Magnetothermal differential switch (also known as ground fault interrupter) with In =
nominal value as stated on the rating plate; - Differential with Id sensitivity = 30 mA.
is no danger of explosion (AD) in the room.
designed for internal use. For installation in any other environment, it will be necessary to change the
cable with the appropriate type (for example H07 VVF for external use).
inside the basin. 6. Insert the jack of the cable into the plug under the motor compartment.
plug on the other end of the cable into the power supply socket (do not use three-way adapters and
reduction adapters) . 8. Switch on the refrigeration switch under the motor compartment and wait for the
green light to come on. . To turn off the appliance, pull the plug out of the socket, after first turning off the 9
special switch. N.B. If during transport or storage the appliance has been placed by mistake in a
horizontal position or has been turned upside down, leave for at least three hours in the correct position
before switching on the power supply (see figure 3).
6. CONTROLS
The appliance is equipped with adjusting controls in a small protected panel located on one side of the
cabinet. 1. Refrigeration unit switch
for checking the temperature inside the appliance.
temperature set-point, which can be changed by pressing button
7. CHECKING CORRECT OPERATION
CHECK THAT: 1. the jack on the power supply cable is correctly inserted into the plug on the cabinet.
2 . The refrigeration unit switch is switched on (green light on). . The thermometer shows the desired
temperature for the goods to be stored.
powered lamps. 5. The room temperature does not exceed that in which the appliance is designed to
work normally, i.e. +30°C, 55% r.h. (climatic class 4).
8. INTERNAL CLEANING
1 . Switch off the appliance. . Remove all goods, placing them in an adequately refrigerated place.
3. Remove the plug from the tank bottom (as described in Chapter 3).
use sharp or pointed metal tools to remove the ice from the evaporator. . Pay attention to the evaporator
fins as they are sharp. . Wipe the walls and accessories of the appliance with a sponge dipped in water 6
with a little sodium bicarbonate. Dry with care.
Operator's guide
4. The connecting cable to the appliance is H05 VVF,
: to switch on the refrigeration unit.
a) Press button
4. The appliance is not exposed to direct sunlight or to high-
2
7
a)
It is properly
c)
Ensure that there
3.
5. Take the supply cable stored
2. Thermometer / Thermostat:
3 "SET or P" once to display the
4 "UP" or button 5 DOWN" "
3
4. Defrost the evaporator. Do not
5
(A) attached I
It complies with
UK
D
E
7. Insert the
F
NL
P
S
DK
FIN
(see fig. 4).
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO