Casals TEKSTUR PLUS 100 LL Manual Del Usuario página 49

ENGLISH
overvoltage category III conditions.
Products equipped with single-phase wiring (M) engines ALWAYS require
•
connection to 220-240V (or only 230V where required) single-phase lines.
Any kind of modification shall be considered as product tampering and
shall nullify the relative warranty.
Precautions must be taken to prevent gas coming from the gas flue pipe
•
or from other fuel combustion units from entering into the room.
Fans have been designed to be mounted on windows or external walls.
•
Items supplied
The fan unit is enclosed in a plastic cylinder incorporated in the motor carrier, which can be entirely accommodated in
the destination pipe and whose short length makes it perfectly compatible with installation near elbow bends (90°), typical
of pipe fittings. The main parts of the appliance are:
• Motor carrier and front panel, made of ABS thermoplastic, impact resistant and anti-UV resin;
• Centrifugal rotor made of PP resin, designed for high performance, low power consumption and low noise emissions;
• Motor with shielded poles, equipped with ball bearings and fitted with a thermal fuse.
• PCB, different depending on the model.
Installation
Figg 2 ÷ 14
Note:
Whatever the orientation of the appliance, the non-return valve must always be in a vertical position (fig.9, 10).
Install the appliance at least 2,3 m from the floor.
Note:
If the non-return valve should come out of place and/or split into its halves, it will be possible to reposition it as shown in
fig 10a, 10b.
49