Bimar S110TT Folleto De Instrucciones página 11

Fax +32 030 9904733

The radiator has an anti-tipping switch inside which allows it to function only when the appliance is
vertical, and switches it off if it tilts.
Selector/Model
0
I
II
III
I/0 turbo switch
Follow these steps to use the radiator correctly:
1) Insert the plug into the power socket.
2) Turn the thermostat dial (B) to the position of the required temperature.
3) Use the specific switches (C ) to turn on the appliance and to select the required power:
4) Turn the switches to "0" position to turn off the appliance, and remove the plug from the power
socket.
5) The S109T model has a turbo heating fan which is started by pressing the switch (F): the turbo
directs the heat to the front of the radiator and can be used separately or together with the
radiator.
6)
To switch off the appliance, turn the thermostat knob to minimum, the selector to "0" and
remove the plug from the power socket.
Never leave the appliance connected to the socket if it is not in use, especially for long periods.
Electronic radiator with turbo and timer, mod. S100TT
The radiator has an on-off switch, electronic and remote controls, and an anti-tipping switch. The
control panel and remote control have keys for selecting and adjusting the various functions; the
control panel also displays the set functions.
In more detail:
- 0/I switch (H). Placed on the side, used to switch the radiator on and off.
- On/off key (1). For access to the functions on the control panel. When "on" is selected, the display
shows the surrounding temperature, and remains dark when "off" is selected because the functions
cannot be activated.
- "Mode" key (2). Used to select the functions described in sequence and shown on the display as
follows:
- symbol " " blinks and signals the "room temp." Function which can be set between 15 and
35°C.
- symbol " " blinks and signals the timer function.
Timer: this function allows setting the operating time and the fan will automatically stop at the end.
To set the operating time, repeatedly press the "MODE" key on the remote control or the control
panel: every time the key is pressed, the time set is changed : the maximum time is 24 hours.
- To start the heat fan, press the " + " key, or to stop, the " – " key.
- "Power" key (3). Used to select the heating power. The radiator should be started on minimum
power – 650W: the display shows "
"power" key to set the maximum power of 1650W: the display will show "
arc lines are yellow and red.
- " + " (4) and " – " (5) keys. Respectively they increase or reduce the time and temperature values
during the setting phase, or they activate (+) or exclude (-) the turbo.
- The radiator also has an anti-tipping switch which allows it to function only when positioned
vertically, and switches it off if it tilts.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
S107.EU S109.EU
0W 0W
600W 1000W
900W 1000W
1500W 2000W
---- ----
" symbol and the arc lines are yellow and red; then press the
11 32
/
Assembly page 11/32
S109T.EU turbo S111.EU
0W
650W 950W
950W 1250W
1600W 2200W
350W
"symbol and the
0W
----