HTW -VP-60FS Manual De Usuario página 11

PEDESTAL FAN HTW-VP-60FS
ASSEMBLY INSTRUCTIONS
1. Front grill
2. Blade nut
3. Blade
4. Grill nut
5. Rear grill
6. Fan head
7. Decorative ring screw
8. Display panel
9. Fan body
10. Body Screw
11. Tube nut
12. Fan tube
13. Base
14. Spacer
15. L-shaped screw
16. Decorative ring
17. Grill Screw
STEPS:
1. Unscrew the L-shaped screw (15) from the fan tube (12), remove the spacer and screw.
2. Install the L-shaped screw with spacer through the hole of the base to connect the pipe, tighten the
screw.
3. Place the base on a dry, level surface. Unscrew the tube nut (11); Pull out the inner tube to the top. (You
may have to push up from below to lift it up.)
4. Install the tube nut and tighten it by turning it clockwise.
5. Place the fan body (9) on top of the inner tube, tighten the body screw.
6. Unscrew the grill nut (4) on the front of the motor by turning it counterclockwise.
7. Mount the rear grill (5) to the front engine cover by matching the 3 holes in the grill with the 3 round
positioning knobs on the front engine cover. Push firmly until the 3 knobs protrude through the 3 holes.
8. Replace and tighten the grill nut (4) by turning it clockwise to hold the rear grill in place.
9. Place the fan blades (3) on the motor shaft matching the slots on the shafts with the slots on the blades,
tighten the Blade to Blade nut (2) by turning it counterclockwise.
10. Test the fan by turning it with your hands, make sure there is no contact with the nut. The fan blade
should rotate freely.
11. Use 3 screws to install the decorative ring in the middle of the front grill.
12. Unscrew the grill screw (17) from the front grill.
13. Mount the front grille (1) to the rear grille (5) by hanging the top hook clip of the front grille over the top of
the rear grille. Close the clamps around the grill, finally put the nut on and screw through the hole in the
bottom edge of the front grill and tighten.
USER MANUAL
ASSEMBLY
11
