Publicidad
Idiomas disponibles
Idiomas disponibles
OWNER'S MANUAL | TROUBLESHOOTING
REPLACING THE CONTROL KNOB'S PRINTED
CIRCUIT BOARD
If the control knob does not work, the PCB may need to be replaced�
Pull out the non-func-
STEP 01
tional control knob and set aside�
to
n
Use a Philips head
STEP 02
screwdriver to remove the two
(2) M4x10 screws from the knob
bezel and set aside�
Remove the knob bezel
STEP 03
and set aside�
n
lift out the knob PCB,
STEP 04
and disconnect the wire from the
back of the knob PCB�
e� In
an
l
Plug the connector into
STEP 05
the new knob PCB�
Reverse the above assembly
steps to reinstall the
control knob�
16
Model: 6303
BLACKSTONEPRODUCTS.COM/SUPPORT
Publicidad
